If this is a multi-Tonal model the most important thing to do before installing any type of flooring is to open as many boxes as possible. Why? Because with high variation flooring, you’re going to have different shades and colors across your boxes. To truly make the right statement with your flooring, open as many boxes as possible to first look at what you have. Lay out the planks temporarily to see how the colors will line up. This is where you can get creative. With high variation flooring, you want to avoid having two similar-looking planks installed next to each other (this point applies only for multi-tonal high variation models)

Install confident on all grade levels / temperature controlled. Can be use for residential and light commercial.

Interior use only. If use on exteriors should be on a non-wet zone an under roof beyond all the covering area.

This floor is not intended to be used as a structural material. If so will be responsability of Installer- Owner

Before installation, check carefully the floor planks for any possible damage or defects. Claims- warranty will not be accepted regarding visual defects after flooring has been installed.

Will be owner-installer responsability if any planks are unacceptable due to color, finish, milling or any other reason, and should be determine to use them, hide in areas like closets, trim off the imperfection, or not install them at all.

The basements, and garages should be dry and ventilated.

5% waste is recommended to add for cutting above the actual square footage. 10% extra material would be better if install diagonal you may require.

An extra box is also recommended that you retain for future repairs (when required).

On very large areas, leave at least 1/4″ for expansion space. And must be placed between the flooring and all vertical obstructions (door jams, walls, staircases, posts, pipes, fixtures, etc.).

Planks should not be glued, and can not screwed, nailed, or otherwise fixed (e.g. closet track, door stopper,) to the subfloor in any way. It must have room to expand and contract freely.

Can be installed in light-wet areas but can not be installed in exterior wet areas like patios or exteriors unless the outdoor area be below a roof.

Be sure that subfloors be Clean, Dry and Flat. If found differences in floor flatness must either be sanded or ground down, or built-up with a suitable floor leveling material because improper substrate or flatness can result in gaps, or poor plank fitting during assembly.

Install confident over most existing floors if clean, flat, dry, and well bonded/secured tile flooring, vinyl flooring, sheet vinyl, VCT, LVT, ceramic tile, and hardwood flooring that have a wood subfloor underneath

Don’t install over cushioned vinyl flooring, or any existing floating floor products.

Carpeting must be removed before laying this floor

This product doesn’t requires acclimation. However leaving at least 24 hours in the area where installation will be performed would be a good practice.

HYDROSTOP doesn’t requires underlayment if subfloor is flat enough. However, if subfloor have evident and clear imperfections an underlayment positioning would be better. HYDROSTOP PREMIUM already comes with a 1mm PAD attached then no additional underlayment is required.